Grating manufacturerTell us how the grating works?

The grating manufacturer said that the multi-beam safety grating is a kind of safety sensor, which can realize early warning, alarm and normal operation by delimiting a certain range in the raster scanning area. After power-on, use the new software to establish a new project and delimit the project safety warning area and safety area. Safety area detection is based on the grating in the coding device to calculate the range you specify.

At the same time, the multi-beam safety grating can be divided and calibrated according to the needs of the site, with more than 8 areas. Prevent people or obstacles from entering the danger area and provide early warning and warning.

There are five lights above the grille. Displays the working status. When delineating a safe zone, the safe zone should be larger than the safe zone. But early warning does not affect production and will make indifference the norm. When someone enters the alarm area, an alarm will be issued and the equipment will stop working.

　　Grating manufacturerSaid, the warning light is yellow, the alarm is red, the pollution light is on the right, and the two green indicator lights are normal. If there is pollution, the dust on the surface of the grille should be cleaned to make it work normally. In an emergency, the alarm can be reset by resetting.

If the reset fails, the mirror can be recalibrated by learning the software. After receiving the next step, signal processing is performed. Therefore, alcohol and non-woven fabrics should be used to regularly maintain and clean the grating mirror, so as not to affect the production of the alarm.

Grating manufacturers say that compared with other electronic products, the principle of grating is relatively simple, and the structure of grating is relatively simple. However, the application range of gratings is very wide, and many machines have to be installed, such as vertical installation, horizontal installation, and diagonal installation. However, if the installation position of the safety grating is not determined well, the use effect is not good.

The grating manufacturer said that the grating mainly realizes operation station protection, boundary protection, area protection, etc. This should be judged according to the situation on the spot! When installing, you must pay attention to the horizontal alignment of the transmitting end and the receiving end of the safety grating, otherwise it will not achieve a good protection effect, and the length of the connecting cable should also be determined according to the mechanical conditions of the site!

　　Grating manufacturerSaid the grating maintenance we want to carry out:

1. Regular inspection: Each grating should be inspected and maintained regularly, and a special person should be responsible for it.

2. Make sure the machine is turned on: Before going to work every day, be sure to check whether the grating is turned on. Only when it is normal can it be officially operated.

3. Cleaning: Develop the habit of cleaning the grille regularly, especially the filter plate, and try to avoid oil and dust. If conditions permit, the grating should be shielded.

4. Adjustment: If the machine tool needs to change the mold or debug the mold, adjust the height and safety distance of the grating to a suitable position after completion.

5. Note: Install the grating next to try not to stack things. This is not easy to damage the grating.

6. Maintenance: The grating should be inspected or maintained once a year by professionals as much as possible. If the grating fails, do not repair it without permission, please ask a professional master to repair it.